The anti-corrosion and heat preservation of fluorine plastic pump plays an important role in the work of the pump. As we all know, the conveying medium of the pump is corrosive, and the temperature of the medium is different, and the degree of corrosion is also different. How to improve the anti-corrosion and heat preservation effect of the pump?Recycling fluoroplasticssmall make up a simple understanding to see it!
Anti-corrosion is the primary problem of the pump. The operating procedures should be followed during the use of the fluorine plastic pump, which can improve the working efficiency and service life of the pump, and effectively reduce the leakage and leakage accidents caused by mechanical failure caused by misoperation. Equipment corrosion problems. Fluoroplastic itself has good corrosion resistance, as long as we are careful not to damage it and pay attention to environmental conditions.
There are also protective measures to prevent corrosion induced by AC transmission lines. Generally speaking, the corrosion caused by AC is much smaller than that caused by DC, which is about 1% lower than DC. However, when the high-voltage AC transmission line is erected in parallel with the pipeline, due to the influence of the electrostatic field and the alternating magnetic field, the AC current will be induced to the metal pipeline, and the influence and harm to the pipeline cannot be ignored. In the case of alternating current and DC superposition, the presence of alternating current will cause depolarization of the electrode surface and accelerate corrosion. In addition to avoiding or shortening the length of parallel line segments as much as possible.
Thermal insulation measures are also essential, especially in low temperature weather. If the equipment is a closed storage equipment, the transfer pipe and valves at various joints shall be insulated. If it is an open storage tank, the surrounding environment must be effectively controlled to remove flammable and explosive materials. It is recommended to heat around the tank to ensure that the medium does not solidify.
Above is this time.Recycling fluoroplasticsSmall make up on the fluorine plastic pump anti-corrosion and insulation of some related knowledge, I hope can help you.