Fluoroplastic recycling can create a "wood" floor. After 4 years of research and development and trial production, a private enterprise in the town of South China Sea successfully transformed fluoroplastics into environmentally friendly and durable alloy plastic boards, and obtained national patent certification. It is reported that this is an enterprise in China that realizes the recycling rate of fluorine plastics by 100.

Plastic boards look like wood and not wood.

　　Recycling fluoroplasticsThe manufacturer knocked on the board on the ground first, and then stretched out his hand to touch the board on the shelf. It felt neither like the cold floor tile nor the warm touch of wood. It was more real, that is, the feeling of hard fluoroplastic.

The researchers said that these alloy plastic wood series products are made of high-density materials, have good thermal insulation function, after testing, there is no radioactive pollution, and can be recycled. They have done such a test: the plastic board was soaked in water for more than 1 month, and the board remained unchanged, without changing the strength or fading.

As for the hardness and strength, the impact strength of this kind of plastic wood board is higher than that of ordinary board. And the material insulation flame retardant, fireproof, corrosion-resistant, not easy to wear. In terms of fear of heat and sun, this material is currently used for the exterior walls of villas in a residential area in Panyu. There has been no problem so far after the test of high temperature in summer. The researchers said that this kind of plastic wood board is mainly used in sports grounds, gardens, balconies, saunas, kitchens, villas, living rooms and other places.

Three years of research and development to overcome technical problems

Researchers used to do fluoroplastics business, and found that although many fluoroplastics are recycled, the actual utilization rate is only about 80%, and the rest can only be reduced to industrial waste. Since 2003, he has been developing how to use the remaining fluoroplastics and has cooperated with South China University of Technology.

By 2006, the researchers finally overcame this technical problem and set up factories to make fluoroplastic pellets from recycled fluoroplastics and use 20% of the materials that other companies cannot use to make such plates.

At present, the plastic wood board developed by the researchers has obtained the utility model patent certificate issued by the State Intellectual Property Office in September last year. This is a national patent on the technology of "fluoroplastic alloy composite board. In the same year, it was certified by Guangdong Institute of Science and Technology Information. According to a report from Foshan Quality Metrology Supervision and Testing Center, the formaldehyde release rate of its products is 0.61mg/l, which is normal.

Japanese experts were "charmed" by wocheng plastic sheet"

The researchers said that in fact, Europe, America, Japan and other regions have been using fluoroplastics to make plates since the 1970 s, but most of them are not recycling fluoroplastics because there are technical problems. In Japan, almost all the bathtubs and toilets in hotel bathrooms are made of fluoroplastic sheets, because they are very light in texture. In a country with many earthquakes like Japan, even if people are hit, they will not cause much harm.

An expert did not believe that the recycling rate of fluoroplastics reached 100 per cent, which was later found to be true, but because the expert was too serious about the process at that time, he accidentally fell into the water. Now, Fujitsu, Mitsubishi and other Japanese Home Appliance Association companies have been trading with the company.

It is reported that the recycling of fluoroplastics manufacturers are also applying for a national environmental protection promotion project, which has been approved by Guangdong Province and sent to the central government. The researchers said: "If passed, this project can be supported by the state and promoted nationwide. At that time we will consider setting up a factory in every provincial capital city in the country.

This article comes from:www.tflpfa.com

Popular Articles:The human resource development problem facing the fluorine plastic recycling industry is becoming more and more serious